US Digital

View the PDF version of this document.

• 

  1. Base Mounting

  Place base onto shaft. Secure base to mounting surface using two screws.

  Transfer Adhesive: Peel off paper backing, place centering tool into center hole of base, slip entering tool onto shaft and slide base and centering tool down onto mounting surface as one piece. Press to form a good bond, then slip centering tool off shaft and continue with standard mounting instructions.

  ---

• 

  2. Spacer Installation

  Place spacer tool on optic module as shown below.

  ---

• 

  3. Codewheel Installation

  Slip codewheel onto shaft until it bottoms out against spacer tool. Spacer tool provides an air gap of 0.07" 0.03". Tighten set screw with either the hex wrench / hex driver while pressing down on codewheel.

  ---

• 

  4. Cover Installation

  Place housing (cover) on. With thumb and finger, squeeze ears together to insure that cover fully latches.