US Digital

View the PDF version of this document.

• 

  1. Base Mounting

  Place base onto shaft. Secure base to mounting surface using two screws.

  Transfer Adhesive: Peel off paper backing, place centering tool into center hole of base, slip centering tool onto shaft and slide base and centering tool down onto mounting surface as one piece. Press to form a good bond, then slip centering tool off shaft and continue with standard mounting instructions.

  ---

• 

  2. Codewheel Placement

  Place codewheel onto shaft with pattern-side down towards base.

  ---

• 

  3. Codewheel Installation

  Position spacer / installation tool onto codewheel. Spacer / installation tool provides an air gap of 0.07" +/- 0.03". Press down firmly until tool bottoms out on base latching ears.

  ---

• 

  4. Cover Installation

  Place housing (cover) on. With thumb and finger, squeeze ears together to insure that cover fully latches.